pro-GLIDE™

pro-GLIDE™ is a gravity feed product display and merchandising system.

Designed and developed in Australia for the domestic and global markets.

Refrigeration: pro-GLIDE™ operates in all refrigerated environments e.g.

  • Cold Vault
  • Open Front Coolers
  • Free Standing Coolers

Ambient: pro-GLIDE™ also operates in non-refrigerated environments e.g.

  • Grocery
  • Petroleum
  • Convenience
  • Pharmacy
  • Liquor Retailer
  • Discount Department Stores

In addition to these, pro-GLIDE™ will be suitable for a variety of other retail and wholesale applications.

The pro-GLIDE™ System pro-GLIDE™ is a gravity feed product display and merchandising tool.

The features and benefits:

  • Enhance product presentation
  • Increase brand presence
  • Consumer ease of use
  • Ability to planogram your new or existing products
  • Re-merchandising flexibility
  • Reduced labour to restock shelves and displays
  • Expandable system of base matting and dividers
  • Reusable components can be interchanged
  • Environmentally friendly made of 100% recyclable materials

The components of the pro-GLIDE™ system are:

  • ( A ) Base Matting
  • ( B ) Product Dividers
  • ( C ) Data Strip

pro-GLIDE™ Matting

The patented matting system allows you to create a custom size pro-GLIDE™ mat to suit your product displays
and merchandising requirements. There are nine different matting components of various sizes, these parts are fully compatible with each other and can interconnect to produce virtually any size configuration.

There are standard size pro-GLIDE™ kits which can be ordered off the shelf. DDi Displays also offers a custom
service to supply kits made specifically to suit your required sizes and fixture dimensions*

The specialised design of the matting allows increased air flow for better air circulation throughout a refrigeration
system where applicable.

DDi can work with you to develop a custom solution for your specific product, for both refrigerated or ambient displays.
Any sizing outside this can be developed as a custom project as required.

pro-GLIDE™ Mat Asembly

The pro-GLIDE™ matting has a simple and secure under over locking tab system, allowing to lock side to side and back to front.

Dividers can be placed at the join of two intersecting mats, so there is no interruption to your product
merchandising layouts.

DDi Displays have an assembly service and in most cases will assemble the pro-GLIDE™ matting prior to shipping
your order.

pro-GLIDE™ Product Dividers

The standard pro-GLIDE™ dividers can be converted to a left or a right hand version as required, by following
these simple instructions.

On the front face of the divider there are snap seams running on both sides of the centre. Place your thumbs
under the side to be removed and work forward and backward until that face snaps off or is weak enough
to break off.

For a left hand divider, remove the left wing as shown. Remove the right wing to create a right handed divider.

Installing pro-GLIDE™ Dividers

The divider needs to be positioned on the matting approximately 10mm to 15mm back from the front edge.
Placing both hands on the divider, apply even downward pressure while pulling forward.

When the divider slides forward make sure it rests hard up against the back face of the pro-GLIDE™ Mat Riser.
There should be no gap between the front face of the divider and the back of the riser. Continue this process
until the shelf is complete.